Photos, descriptions and specs are for general reference and may vary- They may not depict actual Rental unit.

Hand Held Core Drilling Rig
Core Drills

* "Rent Now" is not a reservation or a guarantee of availability. An Associate will contact you once your request has been submitted. Equipment Makes & Models shown may vary from the actual Rental unit you receive.

Ned-Kut 4001

**Bits and accessories are an additional cost***

The 4001 Hand Held Core Drill is the most powerful hand-held drilling machine.  The 3-speed 4001 is fast and efficient in drilling holes in walls, floors, and ceilings. The 4001 Hand Held Core Drill is designed for a variety of materials, including Concrete, Reinforced Concrete, Brick, Stone, Block, Chemical Anchors, and Wedge Anchors.

Friction safety clutch
Built-in water swivel. Cools diamond bit & reduces dust.
In-line ground fault circuit interrupter
3 speed mechanical gear box
Double insulated motor
Drilling Capacity: ½" – 6"
Motor: 17.5 Amp/2000 Watt/110 Volt
Load speeds: 590 RPM, 1500 RPM, 3000 RPM
Recommended drilling:
 Hand held: 1/2" - 4"
Rig mounted: 1/2" - 6"
For additional information on this product please call us at 877-289-7368

Husqvarna DM230

**Bits and accessories are an additional cost***

Husqvarna DM 230 HANDHELD CORE RIG  
New, handheld drill motor with attractive design and functional ergonomics. Soft rear section and a larger contact area mean that it sits better against your body. The machine is modular, and therefore easy to maintain and repair.
Features Husqvarna DM 230  
>If themotor runs at too high a load for a long period, it
will start to pulsate. If the load is not reduced themotor
will shut off, to prevent overheating. Elgard™
significantly increases the machine’s service life.
>Functional ergonomics make the Husqvarna drill
motors easy and convenient to operate.
>An electronic current limiter for softer starts. Full speed is reached about two seconds after the switch is turned on.
> Equipped with Elgard  which uses pulsation to indicate when themachine is overloaded. This extends product life.
> When making a starter hole or cutting through reinforcement speed can be reduced by half using SmartStart.
> SoftStart  – electronic current limiter means full speed is reached about two seconds after start.
> Three-speed water-cooled gearbox for optimal drilling performance and longer service intervals.
> The plastic housing makes it more durable against drops and daily wear.



Voltage 230 / 110V  230 / 110V
Amperage 8 /15A  8 /15A
Power 1850W 1850W
Output RPM   700 / 1700 / 3600 rpm
Output RPM at full load   500 / 1400 / 2900 rpm
Speeds   3
Water coupling G1/4" G1/4"
Rated output,W    1100/0W
Rated current,A   8/15A
Spindle speed idle high speed   900/2150/4500 rpm
Max drill bit diameter, handheld   3 inch
Max drill bit diameter, stand   6 inch
Mounting collar   2.36 "
Spindle thread, outer   11/4" 7UNC
Spindle thread, inner   G1/2"or5/8" 11UNC
UNC water coupling   G1/4"
Weight   15.4 lbs
Sound pressure   90 dB(A)
Sound level   94 dB(A)
Hand arm vibration (Aeq)   2.5m/s²
Power rating   1100W

Husqvarna DM225

**Bits and accessories are an additional cost***